Bavarian Technic software supports sending commands to control units that support them.
Similar to activations, commands are typically used once to make or set adjustments. For example, you can send a command to reset adaptations or service intervals.
Control units that support commands will display the Commands option (as seen highlighted in blue below).
All supported commands are listed under the Commands option for the control unit.
Mouse-over any information or warning icons to view activation-specific pop-up messages.  
To see a list control units that support commands, please check our Model/Feature Matrix.

Here is an example of the Commands screen: 



Here are examples of information  and warning  pop-up messages: